Car Safety: Complete Guide Part 209

Dec 7, 2007 · FMVSS 209 , Seat Belt Assemblies, specifies requirements for seat belt assemblies used in passenger cars , multipurpose passenger vehicles (MPVs), trucks, and buses. The standard requires that a seat belt assembly shall be designed for use by one, and only one, person at any one time. Dec 7, 2007 · FMVSS 209 , Seat Belt Assemblies, specifies requirements for seat belt assemblies used in passenger cars , multipurpose passenger vehicles (MPVs), trucks, and buses. The standard requires that a seat belt assembly shall be designed for use by one, and only one, person at any one time. This block shall consist of two rollers 102 mm in diameter and sufficiently long so that no part of the seat belt assembly touches parts of the block other than the rollers during test. Dec 7, 2007 · FMVSS 209, Seat Belt Assemblies, specifies requirements for seat belt assemblies used in passenger cars, multipurpose passenger vehicles (MPVs), trucks, and buses. The standard requires that a seat belt assembly shall be designed for use by one, and only one, person at any one time. FMVSS 209, Seat Belt Assemb-lies, was the first standard to become effective on March 1, 1967. A number of FMVSS became effective for vehicles manufactured on and after January 1, 1968. Subsequently, other FMVSS have been issued. This booklet lists the Federal MotorVehicleSafety Standards that were in effect as of October 2003, and provides a brief summary of each safety standard. It also provides similar information on other Federal consumer information regulations and requirements. This document provides the test procedures used by the National Highway Traffic Safety Administration (NHTSA) for testing seat belt assemblies to the requirements of Federal Motor Vehicle Safety Standard 209. Oct 1, 2011 · 49 CFR 571.209 - Standard No. 209; Seat belt assemblies.